In , Craden delivered its first DP4 passbook printer and changed the banking industry’s printer landscape forever. Its drive knob is in the center of the cartridge. Turn off power and unplug the AC Cord. You may also like. Page 34 The cabinet can be cleaned with a damp cloth and a mild, liquid soap or detergent. 
| Uploader: | Vudolrajas |
| Date Added: | 21 June 2009 |
| File Size: | 65.39 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 56254 |
| Price: | Free* [*Free Regsitration Required] |
It will operate from 50 or 60 Hz at either setting. These parameters are factory selected specifically for each printer mechanism and recorded on the label next to the display inside the printer.
Craden DP6 Financial Teller Passbook Printer
Windows drivers are available and several emulations provide “plug in and go” capability. ESC A must precede each line of 60 dpi data with a maximum of data bytes. Page 28 Phase current Current current Control Comp. Page of 62 Go. Clean the tip of the printhead nose where the printwires extend from the printhead with an alcohol wetted napkin.
Be the first to write a review. Remove the cabinet see 5. No Document Motion 3. Lexmark Dot Matrix Printer. The label on the back indicates the current setting.
The DP7 uses shorter screws on the side closer to the transformer. Flex the plastic ribbon shield and remove it from its holder. Repeat steps 2 and 3 for the leftmost roller segment and the roller spring tensioning screw on the left side plate. If several minutes of continuous printing have just been finished, the printhead and carriage may be hot to the touch. Page 49 Carriage drives into the left side of the printer. Remove the sensor connector cover and check that the respective sensor wires are seated in their individual connector slots.
Carriage drives into the left side of the printer.
Skip to main content. This is the price excluding shipping and handling fees a seller has provided at which the same item, or one that is nearly identical to it, is being offered for sale or has been offered for sale in the recent past.
If the ribbon is caught on the front of the printhead nose use a pen point to push it into place. All parts are either permanently lubricated or are designed to operate dry. The cabinet can be cleaned with a damp cloth and a mild, liquid soap or detergent. Missing Dots If it is OK, replace the flex cable. Heading 2 This is an example of the content for a specific image in the Nivo slider.
Page 17 ENQ only after all previously received commands have been executed. They do not usually need to be modified by the user.
DP4, DP6 and DP7 Notes
If not, problem is in switching power supply or power OK circuitry. Page 23 Note that regardless cradwn interface is used DSR must be active for the printer to receive commands and CTS must also be active for the printer to transmit status. Push the wheel guide against the guide wheel and insure that the wheel guide arms are horizontal. On units with serial numbers below the gap must be adjusted by repositioning the gap plate as described for the DP6 in 5.
If the new cartridge has a plastic ribbon shield attached, remove it. In the early ‘s, the electronics industry had undergone incredible changes and as such, much of the technology had grown leaving early ‘s components by the wayside.
Show More Show Less. The mechanism consists of a printhead, a printhead drive assembly and a document drive assembly. They may adversely affect operation.
Private Softwares Cloud 